11
How to Assemble the Blades and Light Kit
x 15
x 15
FIBER
WASHER
3/16
˝
-24
WASHER HEAD
SCREWS
HARDWARE USED:
x 10
1/4
˝
-20
SCREWS
HARDWARE USED:
BLADE
3/16
˝
-24 WASHER HEAD
SCREW AND FIBER
WASHER (3 each per blade)
BLADE HOLDER
Figure 1
MOTOR
ASSEMB
LY
1/4
˝
-20 SCREWS
(2 per assembly)
BLADE HOLDER
SUPPORT
BRACKET
HOUSING LIGHT
KIT ASSEMBLY
Figure 3
1.
Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a Phillips screwdriver, tighten 3/16
˝
-24
washer head screws and fiber washers to secure
the blade to the blade arm (Figure 1).
2.
Secure the blade holders to the motor support
s located
e
l
o
h
e
h
t
h
g
u
o
r
h
t
s
w
e
r
c
s
0
2
-
4
˝
/
1
e
h
t
g
n
i
s
u
on the bottom of the motor support (Figure 2).
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
3.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the light plate assembly to the
support bracket using the two key slots in the
socket plate. Replace the third screw and securely
tighten all three screws (Figure 3).
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
SCREWS (3)
Figure 2
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
light kit.
CAUTION
