Final Fan Assembly
CAUTION
To avoid possible electrical shock, be sure electricity is
turned off before installing downlight assembly.
1.
Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws. (Figure 1)
Light Plate
Assembly
Motor
Assembly
Figure 2
2.
Connect the 2 single-pin connectors from the light
plate assembly to the 2 single-pin connectors from the
motor assembly.
(Figure 2)
Figure 1
10
Installing the Canopy Housing
NOTE:
1.
Remove the two shoulder screws in the Hanger Bracket
This step is applicable
after
the necessary wiring
is completed.
with a screwdriver. Securely attach the Canopy Housing
with the shoulder screws provided and then tighten the
screws (Figure 1a).
▲
WARNING
To avoid possible fire or shock, make sure that the
spliced electrical wires are turned upward and completely
pushed carefully up into the junction box and not pinched
between the housing and the ceiling.
Figure 1a
Figure 1b
2.
Securely attach the Canopy Screw Cover over the
shoulder screws in the Hanger Bracket utilizing the keyslot
twist-lock feature (Figure 1b).
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
CAUTION
