How to Assemble Your Ceiling Fan
2.
The fan comes with blue, black, white 80" wires.
s
e
ri
w
e
h
t
e
t
u
o
R
.
s
e
ri
w
e
e
r
h
t
e
h
t
t
s
i
w
t
n
u
d
n
a
e
t
a
r
a
p
e
S
through the Downrod.
NOTE:
You will be using either the 6" or the optional
downrod purchased separately.
Pin
Clevin Pin
Setscrew
Hanger
Ball
Hairpin
clip
Figure 1
1.
Remove the Clevis Pin, Hairpin Clip, Hanger Ball and
Pin by loosening the setscrew in the Hanger Ball. Retain
the Clevis Pin, Hairpin Clip, Hanger Ball and Pin for
reinstallation. (Figure 1)
6
Electrical and Structural Requirements (Continued)
If your fan is to replace an existing light fixture, turn
electricity off at the main fuse box at this time and
remove the existing light fixture.
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
WARNING
Deep box with brace (Figure 3)
Paired with a deep box, this hanger is meant to span
between two joists and takes the place of wooden
blocking.
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
WARNING
Figure 3
CEILING JOIST
CEILING
OUTLET BOX
To reduce the risk of fire, electric shock, or personal
injury, mount to outlet box marked acceptable for fan
support of 15.9 kg (35 lbs) or less and use mounting
screws provided with the outlet box. Most outlet boxes
commonly used for the support of luminaires are not
acceptable for fan support and may need to be
replaced, consult a qualified electrician if in doubt.
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
WARNING
