9
Pin
1.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 6. (Figure 1)
Figure 1
3.
Route the black and white wires through the
downrod. (Figure 3)
4.
Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes in
the downrod support with holes in the downrod. Secure
clevis pin with hairpin clip. Install and tighten the two
previously removed set screws with locking nuts in the
downrod support. (Figure 4)
2.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
Figure 2
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
5.
Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
Ceiling Canopy
Canopy Screw
Cover
Motor Coupling
Cover
Downrod
Hanger Ball
Set Screw
Hairpin
Clip
Clevis Pin
Black and White Wires
Downrod
Downrod
Set Screws and
Locking Nuts (2)
How to Assemble Your Ceiling Fan
Figure 3
Figure 4
Hairpin Clip
Clevis Pin
Figure 5
