2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
3.
Remove the battery cover from remote control by
screwdriver and retain the screw for later. (Figure 3)
Figure 2
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
Figure 3
3V CR2032
Battery (2 pcs)
4.
To make fan operational, install two 3V batteries
(included) in hand-held remote transmitter, with fan
power off. Then, follow the remote code setting
process. If not used for long periods of time, remove
battery to prevent damage to transmitter. Store the
remote away from excessive heat or humidly.
(Figure 4)
WARNING
Chemical Burn Hazard. Keep batteries away from
children.
How to Operate Your Ceiling Fan (Continued)
15
5.
To set the remote code in the same positions as
the receiver, use a small screwdriver or ball point pen
(neither included) to slide dip switches firmly up or
down. (Figure 5)
NOTE:
Factory setting is all up. Do not use this
position.
NOTE:
The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
Remote Control
Dip Switch
Main Fuse Box
Figure 4
Figure 5