- 6 -
Bu� on confi gura� on cont.
OFF function
A short press on the monostable button will:
switching off the relay receiver (*),
lowering a roller shutter on roller shutter controllers (*),
switching off the light in lighting dimmers.
The OFF mode can be used to force a group of receivers off at the same time.
BIS function
This mode is recommended when bistable pushbuttons are connected. When the-
button is switched on, an ON command is sent, when the pushbutton is pressed, this
command will be repeated additionally every approx. 60 s. When the pushbutton is
switched off, the OFF command is sent, when the pushbutton is off, this command
will be repeated approximately every 60 s. This solution is dedicated to cases where a
receiver (or a group of receivers) is to be switched on for a (potentially long) time when
the button is pressed, e.g. for remote control of circulating pumps or fans.
Due to the nature of transmission and retransmission it is not recommended
to use the same button on the transmitter more often than every 2 seconds.
Switching the receiver may occur with a slight delay.
It is not recommended to use remote bi-stable transmitters to control a group
of receivers due to the risk of the switching status desynchronization (espe-
cially when working with larger distances and/or simultaneous use of the local
buttons on the receivers).
(*) In the case of multifunction receivers, the action of the button may additionally depend on the selected
programme of operation of the receiver.
