TROUBLESHOOTING:
MODEL NUMBER
RATED
VOLATGE
RATED POWER FOR
DC MOTOR
RATED LIGHT
POWER
CLFCORLED
DIMMABLE
CFFCOR4WH
240VAC
38W
18W (LIGHT KIT)
NA
CFFCOR4KO
240VAC
38W
18W (LIGHT KIT)
NA
TECHNICAL DATA:
WARRANTY CONDITIONS:
Installation must be performed by a qualified and licensed electrician. The warranty will not apply if
the ceiling fan is installed by other than a licensed electrician. Problems arising from incorrect
installation are not covered by warranty. The cost of repairs and / or service call arising from
incorrect installation, not due to faulty material or workmanship in accordance with the Fanco
warranty, will be payable by the purchaser at the time of repair.
This warranty is only valid for appliances used according to the manufacturer’s instructions.
Balance kit must have been used before Warranties for noise related or wobble are considered.
The manufacturer does not accept liability for any direct or consequential damage, loss or other
expense arising from misuse or incorrect installation and operation of the appliance.
Warranty will only be provided where proof of qualified electrical installation is provided. Eg.
Electrical Safety Certificate.
The manufacturer will not accept in home expenses unless authorisation is granted prior to work
commencing, and a CA number allocated.
The in-home component of this warranty covers only actual electrical work undertaken, on or to the
ceiling fan.
Where a service call is undertaken and no fault is found with the ceiling fan, or where the fault is not
covered under the terms of this warranty, a call-out fee may be charged.
This product is not designed or intended for industrial or commercial use.
11
TROUBLE
POSSIBLE CAUSE
SUGGESTED REMEDY
Fan will not start
A) Fuse blown or circuit breaker tripped
A) Check fuses and circuit breakers
B) Loose wire connections or plugs to
fan/controller
B) Check wire connections and ensure plugs
are positively connected
C) Battery flat in remote control
C) Replace 12V battery in remote control
Fan wobbles
A) Fan blades are not horiziontal to the
ceiling
A) Retighten all screws on blades.
Do not
make
any adjustments by applying pressure up or
down on blades
B) Blade screws are loose
B) Make sure all screws are tightened
C) Blades are not balanced enough
C) Use the provided balancing kit to balance
the blades
Fan sounds noisy
A) Loose fan blades
A) Retighten all screws on blades.
B) Ceiling fan not secured against ceiling
B) Retighten all screws on the mounting
bracket
Mechanical noise
A) Fan has not settled in fully
A) Allow at least 8 hours of use for the fan
to set in
B) Ensure
