Fanaway Fraser Installation Instructions
5 |
P a g e F R A S E R
V e r s i o n 1 . 0 1 2 / 2 0 1 9
To hang your fan where there is an existing fixture but no ceiling joist, you may need an installation
hanger bar (C) as shown in
Fig.5
. Make sure the hanger bar you purchase has been designed for use
with ceiling fans.
INSTALLING THE FAN
INSTALLING THE DOWN ROD (Fig. 6)
1.
Feed the down rod (5) through the canopy (4) and the bolt and pin cover (6).
2.
Remove the ball joint (2) by loosening the set screw (3), insert the motor wires through the down rod
then secure the ball joint back to the down rod.
3.
Insert the down rod to the coupling (7), line up the coupling holes with the down rod holes and insert
the bolt (8). Then insert the pin (9) to the end of the bolt.
4.
Finally secure the down rod and coupling by tightening the two set screws (10) on the coupling.
Fig. 6
Fig. 5
Fig. 6
