Fält Communications 2016 ©
162187 Manual Fältcom ECII® Flex V024D 2016-02-23
Page 35 of 41
7.3 Ending a call
End the alarm call by pressing
0, END.
If the alarm is ended with time disconnection and the
call is not acknowledged the Fältcom ECII® Flex will make a new alarm call to the next alarm
receiver. Please note that this will only happen when alarms are sent to a standard telephone.
When sending alarms to an automatic alarm centre no further calls will be made after the
alarm has been acknowledged.
If functions “Simplified acknowledge” (320) or “Disconnected acknowledge” (321, 323) are
used the alarm is disconnected by pressing
*, END (320, 321, 323)
. No more calls will be
made.
7.4 Repeat Message 2
If the receiver wants to hear the recorded message 2 once again press
1, REPEAT MES-
SAGE 2
. The message can be repeated at any time during the call.
7.5 Forwarding a call
If you want to forward the alarm to the next alarm receiver, press
2, FORWARD
. The alarm is
then closed, and the lift phone will call the next programmed alarm receiver. Please note that
the alarm call has to be acknowledged before forwarding the call.
7.6 Termination of active alarm mode
If the function active alarm mode is activated and the product is in active alarm mode, i.e.
there has been an alarm and the Fältcom ECII® Flex is open for incoming calls, you can
close the incoming calls window by pressing the key
5,
TERMINATE ALARM MODE
. The call
is automatically disconnected.
7.7 Speech switching
If the automatic speech switching is not satisfactory, you can change to manual speech
switching
8, SIMPLEX TALK
and
7, SIMPLEX LISTEN
. Revert to automatic speech switching
by pressing
4, ACKNOWLEDGE
.
7.8 Calls to a lift phone
7.8.1 Multiple units on the line
If answering function is activated, or if alarm mode function is programmed, and Fältcom
ECII® Flex is in active alarm mode, it is possible make a call to the Fältcom ECII® Flex from a
tone dialing phone or a mobile phone according to the following:
1.
Dial the number to the lift phone.
2.
After one ring signal the first Fältcom ECII® Flex answers and sends a modem (fax)
tone. Wait for the modem tone to stop and listen for a 3-tone message.
3.
Press # and ID-number to the wanted lift phone (1-9). For instance #2 for lift phone 2
