FALMEC Domino 38, Инструкция пользователя

Страница: 18 / 60

18
ADDITIONAL FUNCTIONS
"38 PLUS" MODEL
STOP AND GO
This function allows to temporarily stop cooking and restore it with the same
settings.
to enable touch the key .
If the function is not deactivated within 10 minutes, the cooker switches off.
For deactivation
Touch the key and within 5 seconds completely slide the slider to right.
AUTOMATIC PROGRAMMING OF THE COOKING
This function allows to speed up the start of cooking.
The procedure is the following:
1 - turn on the cooker
2 - touch for more than 2 seconds the desired level of cooking:
on the display will be displayed and the desired level of cooking
.
For a certain period the cooking area will work at the maximum
power to then rech the set level.
To deactivate the function:
touch again the control
.
RESTORE FUNCTION
After turning off the cooker, it is possible to restore the last selected settings:
· Status of cooking of all cooking areas (power).
· Minutes and seconds of the timer by programmed cooking areas.
· Automatic programming of cooking.
The restore procedure is the following:
- turn on the cooker.
· touch within 6 seconds the key .
Previous settings are restored.
WHAT TO DO IN CASE OF PROBLEMS
The cooker or cooking areas do not turn on:
· The cooker is not connected to the electric network.
· The protection fuse is released.
· Check if the block is not active.
· Keys are covered with water or grease.
· An object is placed on the keys.
The symbol is displayed .
· There is no saucepan on the cooking area.
· The container used is not compatible with cooktops.
· The diameter of the saucepan bottom is too small compared to the cooking
area.
The symbol [E] is displayed:
· Disconnect and connect the cooker.
· Contact the after-sales centre.
One of the area or the entire cooker turns off:
· The safety overheating system is active;
· The cooker or one cooking area remains on for too long;
· one or more keys are covered;
· one of the saucepans is empty and the bottom overheated.
The fan keeps on working after the cooker shutdown:
· This is not a malfunction: the fan keeps on protecting the electronic power unit
of the device.
· The fan stops automatically.
The symbol [E2] or [E H] is displayed:
· The cooker overheated, leave it cool and then turn it on again.
The symbol [E6] is displayed:
· Defective electrical network. Check the network voltage and frequency.
The symbol [E8] is displayed:
· The air inlet of the fan is clogged, clean it.
CLEANING AND MAINTENANCE INSTRUCTIONS
ATTENTION!
For cleaning, never use a steam equipment.
Before cleaning the cooker, make sure that it is at room temperature.
Always clean the cooker after each use with a specific cleanser for pyroceram.
Do not use products containing:
- corrosive agents (soda, acids, ammoniac).
- abrasive agents (dusts or paste).
Do not use pointed or abrasive objects.
After cleaning, dry the appliance with a soft cloth.
If the appliance is built-in over an oven or an electric kitchen fitted with pyrolytic
system do not operate it while the pyrolytic procedure is under way, as the over-
heating protection of the cooker can be released (see relevant chapter).
DISPOSAL AFTER END OF USEFUL LIFE
The crossed-out wheeled bin symbol on the appliance means that
the
product is WEEE
,
i.e. "Waste electrical and electronic equipment", ac-
cordingly
it must not be disposed of with unsorted waste
(i.e. with
"mixed household waste"), but it must be disposed of separately so
that it can undergo specific operations for its re-use, or a specific treatment, to
remove and safely dispose of any substances that may be harmful to the envi-
ronment and remove the raw materials that can be recycled. Proper disposal of
these products contributes to saving valuable resources and avoid potential
negative effects on personal health and the environment, which may be caused
by inappropriate disposal of waste.
You are kindly asked to contact your local authorities for further information
regarding the designated waste collection points nearest to you. Penalties for
improper disposal of such waste can be applied in compliance with national
regulations.
INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES
The EU WEEE Directive was implemented differently in each country, accord-
ingly, if you wish to dispose of this appliance we suggest contacting your local
authorities or dealer to find out what the correct method of disposal is.
INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUNTRIES
The crossed-out trash or refuse bin symbol is only valid in the European Union: if
you wish to dispose of this appliance in other countries, we suggest contacting
your local authorities or dealer to find out what the correct method of disposal is.
WARNING!
The Manufacturer reserves the right to make changes to the equipment at any
time and without prior notice. Printing, translation and reproduction, even par-
tial, of this manual are bound by the Manufacturer's authorisation.
Technical information, graphic representations and specifications in this manual
are for information purposes and cannot be divulged.
This manual is written in Italian. The Manufacturer is not responsible for any tran-
scription or translation errors.