44
NON-HEATED TACK TANK INSTRUCTIONS
CAUTION: NEVER FILL THE TOP CYLINDER OF THE TACK TANK WITH TACK MATERIAL.
!!
1. Open the door of the tack fill spout.
2. Fill tack tank with the amount of material that
will be used in a day.
NOTICE: The tank is not designed to be a
storage reservoir and must be emptied at the
end of a workday.
3. Clean off any excess tack material with an environmental-friendly asphalt release agent.
DANGER: NEVER USE A FLAMMABLE MATERIAL TO CLEAN NEAR THE PATCHER.
4. Close tack tank door.
5. Place tack bucket under the tack tank spout.
6. Lift up on the material supply valve located at the base of the tack tank.
7. Close the material supply valve on the bottom of the tack tank when the appropriate
level of tack has been drawn.
8. Apply tack material based on organization's procedures.
9. Remove all visible tack material with an environmental-friendly tack release agent.
DANGER: NEVER USE A FLAMMABLE LIQUID TO CLEAN NEAR THE PATCHER.
WHEN FINISHED:
10. Remove remaining tack material from tank at the end of each day.
