6
b> Door Open
c> Boot Open
d> Foot brake pushed down
e> Hand brake released
* After remote engine start has been used, please follow the following steps to enter the vehicle.
a> Disarm the system if armed.
b> Insert the car key into the ignition then switch it to <On>, not Start.
The engine will shut down if you apply the foot or hand brakes before inserting the car key into
the ignition and switching <On>.
B-14) Reservation Mode (Remote Engine Start for Manual Transmissions Only)
For manual transmission cars reservation mode is used for safety reasons. Ensure that Car Type
is set to Manual (please refer to # 15 in Programming Option Table)
1) Follow the below procedure to set up the reservation mode.
a> After arriving at the destination, leave the ignition on and shift the gear to the neutral
position.
b> Pull up the hand brake.
c> Remove the key from the ignition. The engine will keep running.
d> Exit the vehicle and close the door after Step c. The engine will shut down and the
reservation mode is set up. (if the turbo timer feature is enabled the engine will keep running for
120 or 180 seconds before shutting down).
Important:
Reservation mode must be set up as above every time before exiting manual
transmission cars in order to activate the remote start.
2) Important requirements to activate the reservation mode:
a> The transmission gear must be placed in the neutral position.
b> The hand brake must be pulled up.
c> Do not set the reservation mode when people are in the vehicle.
d> Do not activate the remote engine start when people are in the vehicle
3) Cancel the Reservation Mode
The reservation mode will be cancelled if any of the following cases happen.
a> The parking brake is released when the engine is running.
b> Button 4 is pressed for 3 seconds between Step c and d during setting of the reservation
mode.
c> The valet mode is applied after completing the reservation mode.
d> Doors opened after completing the reservation mode without remote engine start.
B-15) LED Status Indicator
If the system was triggered whilst armed the siren will chirp four times on disarm, the hazard
lights will flash twice and the LED will flash to indicate the triggered zone as follows:
1 Flash
: Shock Sensor
2 Flashes
: Boot/Bonnet
3 Flashes
: Door
4 Flashes
: Ignition
System Status:
Slow Flash
: Arm
Fast Flash
: Auto Re-Arm/Passive Arming/Anti-Hijacking
Steady Light : Valet Mode
No Light
: Disarm
*The LED memory will be cleared by turning the ignition on or disarming and arming the system
again.
