4
B) System Features
B-1) Remote Transmitter Code Learning
The included remotes control are programmed to the system before they leave the factory.
Follow the below procedure to program a new remote control:
a> Follow the below procedure to program a new remote control.
With the alarm disarmed, and the doors CLOSED, switch the ignition ON/OFF 3 times (within 1
second of each other) and then back to the ON position.
The siren will sound for 2 seconds to indicate the alarm is in code learning mode.
b> To program the new remote control press button (1) within 10 seconds.
The siren will chirp and the hazard lights flash twice to confirm that the code has
been learned. Follow the same procedure for second, third and fourth remote transmitter.
c> If the ignition is turned OFF or button (1) is not pressed within 10 seconds, the system will
quit the code-learning mode. If this happens you must start again from the first step.
d> Up to 4 remote control transmitters can be programmed to the system.
B-2) Remote Arm
To arm the system, after exiting the vehicle and closing all doors, press button (1) once. The
siren will chirp once and the hazard lights flash once. The doors will be locked and immobiliser
will be on and armed. Now the system is ready to respond if intrusion attempts are detected.
If the doors or boot are opened, or the first stage shock senor is triggered, the siren will chirp
three times and the hazard lights flash three times at the same time. The violated zones will be
by-passed and the system enters into the arm mode.
B-3) Remote Disarm
To disarm the system, simply press button (2) once while the system is armed.
The siren will chirp twice and the hazard lights flash twice at the same time.
If the alarm has been trigged while the system was armed, the siren will chirp 4 times and the
parking lights flash 4 times to warn you.
B-4) Enhanced System Alerts
To protect your vehicle, the system will emit a different alert depending on why the alarm was
activated.
a> Pre-warn sensor (first-stage sensor) triggered: Light impact will activate the pre-warn sensor.
Remote LCD transmitter will sounds three short chirps with impact icon displayed.
b> Shock sensor (second-stage sensor) triggered: Heavy impact will activate the second-stage
sensor. The hazard lights will flash and siren sound for one cycle (30 or 60 seconds based on the
programmed default).
c>
Ignition on: Siren will sound until the ignition is off.
d> Door opened and then closed: The hazard lights will flash and siren sound for one cycle (30
or 60 seconds).
e> Door opened and not closed: Siren will sound for three cycles (siren will stop for 5 seconds
and sound again for next cycle). Door sensors will be bypassed until they are closed.
f> Bonnet opened and then closed: The hazard lights will flash and siren sound for one cycle (30
or 60 seconds).
g> Bonnet opened and not closed: Siren will sound for three cycles (siren will stop for 5 seconds
and sound again for next cycle). Bonnet switch will be bypassed until it is closed.
h> Alarm triggered: Press button (1), siren will chirp once, doors lock and the system is still
armed or Press button (2) siren will chirp four times, doors unlock, immobiliser will turn off and
LED turns off or flashes rapidly.
