Falcon G2102, Инструкции по установке и обслуживанию

Страница: 12 / 16

3.4.2 Open Top Thermocouple (G2102 only
)
Remove hob as detailed in Section 3.2.3.
Remove nut securing thermocouple to burner support bracket and pull thermocouple through support bracket from
underside.
Undo thermocouple connection at FFD section of gas tap and carefully remove thermocouple from hob. Repeat for
all hob burners.
Replace in reverse order taking care to position tip correctly in relation to burner ports. Thermocouple tip should be
32mm above support bracket. Ensure tip does not touch burner cap when fully re-assembled.
3.5 OVEN PIEZO UNIT
The piezo unit is secured to oven control panel.
Open oven control panel as detailed in Section 3.2.1.
Remove ignition lead and undo fixing at control panel rear.
Replace in reverse order.
3.6 OVEN PILOT BURNER ASSEMBLY
Withdraw oven control panel and remove burner chamber grille.
Undo rear nuts securing pilot supply tube and thermocouple. Pilot injector will be released, take care not to lose it.
Remove spark electrode lead.
Remove screws securing pilot bracket.
Remove pilot burner with mounting bracket.
If desired, pilot burner can now be dismantled from bracket by removing two fixings.
Replace in reverse order.
3.7 REMOVAL and CLEANING of BURNERS
3.7.1 Oven Burner
To Remove
Withdraw oven control panel as detailed in Section 3.2.1 and remove burner chamber grille.
Remove pilot burner assembly as detailed in Section 3.6.
From inside burner chamber, release compression fitting nut on burner feed-pipe.
Remove fixings securing main burner bracket to oven base frame.
Remove burner complete with mounting bracket, slightly left to clear pipe, then remove from front.
To Clean
Remove all accumulated debris from burner by lightly brushing, afterwards shaking or blowing clean.
Replace in reverse order.
3.7.2 Open Top Burner (G2102 only)
To Remove
Remove lift-off hob components as detailed in Section 3.2.3.
Undo gas supply pipe compression fitting and burner body retaining nut.
Take care not to deform this, the top surface must remain flat.
Remove burner body.
Replace in reverse order.
To Clean
Detailed cleaning procedure is given in Section 4 of User Instructions.
3.8 INJECTORS
If injector requires cleaning, do so with a wooden splinter or similar non-metallic instrument. Do not broach with a
drill as this might effectively increase the diameter of injector orifice.
3.8.1 Oven Injector
Remove burner as detailed in Section 3.7 then remove injector by undoing it from burner.
Separate injector from elbow fitting.
Replace in reverse order.
3.8.2 Open Top Injectors (G2102 only)