8
SECTION 3
– SERVICING AND CONVERSION
Important
BEFORE ATTEMPTING ANY SERVICING, ENSURE THAT THE ISOLATING COCK IS TURNED OFF AND
CANNOT BE INADVERTENTLY TURNED ON.
AFTER ANY MAINTENANCE TASK, CHECK THE APPLIANCE TO ENSURE THAT IT PERFORMS
CORRECTLY AND CARRY OUT ANY NECESSARY ADJUSTMENTS AS DETAILED IN SECTION 1.
After carrying out any servicing or exchange of gas carrying components:
ALWAYS CHECK FOR GAS TIGHTNESS
3.1
Conversion
For conversion to NATURAL GAS, fit the correct governor and set the burner pressure.
For conversion to PROPANE GAS, remove the governor from the gas circuit.
Other considerations
CHANGE INJECTORS (refer to Section 1.9 for sizes, and section 3.3 for instructions)
ADJUST BYPASS SCREW TO SET LOW RATES (Refer to Section 3.8) in gas taps and any oven
thermostat.
CHANGE DATA PLATE
3.2
Removal of Panels
3.2.1 RH Outer Panel
Remove fixings which secure panel bottom flange to
underside of base. Slide panel back to withdraw two
pins which locate rear of vertical control panel. Pull
panel out slightly at bottom then draw it down to
clear top flange which engages under hob edge lip.
To replace, the stainless steel outer panels are
fitted between hob and base of appliance
approximately 25mm to rear of their final position.
Both panels are then slid forward into position, the
RH one to engage its locating pins into the slots in
the rear of vertical control panels and LH to align
flush with front frame. The fixings (2 off) engage the
bottom flange of the side panels up through holes in
the edge of the base panel (see Figure 5).
3.2.2 Bottom Front Panel
Lift to unhook and lower. Undo lower RH hinge pin and remove panel. Replace in reverse order.
3.2.3 Vertical Control Panel
Pull off control knobs. Remove fixings which secure panel bottom flange to base plate. Withdraw panel
outward slightly at bottom to clear control spindles and pull it down to free top locating flange. Replace in
reverse order.
3.2.4 Top Facia Panel
To remove control panel, remove control knobs and pull panel toward front of appliance to unclip. To
replace, line bullets up with clips and push until you hear a click.
3.2.5 Oven Door
a) Remove control panel as detailed in Section 3.2.3
b) Unhook bottom front panel and lower down.
c) Close oven door.
d) Using a screwdriver for leverage, unhook door quadrant springs. Support door to prevent accidental
opening whilst removing springs. Open door approximately three quarters of its travel and lift slightly
to clear hinge pins.
Pull forward to allow quadrants to slide through the front frame apertures.
e) Replace in reverse order.
