Falcon DAEDALUS, Руководство пользователя, Страница: 6 / 20

Because of the obvious temptation to take Falcon out of the box and
turn it on to full speed (it’s a splendid bit of grandeur!), your tension
belt is not installed for shipping. If you’ve installed it already, make
sure to remove the tension belt if you want to operate the wheel
without actually spinning yarn! The tension belt (even at low tension)
will cause the bobbin to be “stalled” and not spin, while the flyer
could be going at high speed. The bobbin bearings were carefully
chosen for the utmost performance while spinning yarn, where those
bearings are operating at a relatively low rpm. Turning the wheel on to
high speeds with the bobbin stalled can cause premature wear on the
bobbins bearings.
Before you get started, always make sure the direction switch on the
Speed Controller is in the middle (neutral) position, or else the wheel
will attempt to start when you’re not ready. If you purchased your
speed controller at the same time as your Falcon, it has been limited
to a max speed of 50% in the settings. If you already have a speed
controller, use caution as it will have unlimited speed. Please read the
directions for using the Speed Controller to change this setting and
unlock the full speed potential, as well as more in-depth information
on speed controller programming.
Start it up!