Page 3 of 12
1.1
Check that the product model is correct for the required application.
1.2
Check that all parts listed on the Bill of Material are in the shipping container.
1.3
Check the architectural drawings and final approved shop drawings for the position
of frame and structural openings.
1.4
Check header and frame dimensions and required clearances.
26”
26”
1.5
Check Door Width:
26” minimum for 26” Push Operator
1/8” max reveal
30” minimum for 26” Pull Operator
1.6
Check that Door Weight is 200 lbs. or less. For heavier door, consult factory.
1.7
Check that a 115 volt, single phase, 60 Hz, fused 15 amp, 3-wire power supply is available
at the side jamb with approximately 12” of wire available to connect to the Operator.
UL approved flexible conduit is recommended for the 115 volt power line.
The 115 volt power supply must be a dedicated circuit from the main circuit breaker panel
and must NOT be connected into any building lighting system that operates florescent
lights.
1. PRE-INSTALLATI ON SITE & PRODUCT CHECK
