Page 11 of 12
7.1
Remove all tools, installation equipment and debris from the vicinity of the door.
7.2
MANDATORY: Install all Safety, Traffic Control and Instruction Labels onto the door,
as required.
Failure to do this will leave the INSTALLER LIABLE for any accidents that occur.
7.3
Give verbal instruction on how to properly operate the door to the owner or
person in charge.
7.4
Give verbal instruction to the owner or person in charge on periodic inspection of the
door for the following:
•
Occasional damage
•
Developing problems
•
Minor preventative maintenance
7.5
Provide the owner or person in charge with a contact name and phone number to call
for future service and maintenance.
IMPORTANT
Be sure to install all Safety, Traffic Control and Instruction Labels
onto the door, as required
7. RELEASE FOR SERVICE
8.1
Operation:
8.1.1
Sizing
From start-up (Sizing), the door will activate via:
Main Input (Main Act and Main Act Com).
The first motion of the door will be towards the Door Open position. The speed during
Sizing is automatic and cannot be set from a potentiometer.
The door drives to full open and the system sets the open counter to full open.
The door closes at Closing Speed. The system sets the closed counter to Full Closed
when the latch goes up at the Closed position.
The system calculates all other parameters required for normal operation based on the
two values of Full Open and Full Closed.
8. FALCON SOFTWARE
