Falcon 1092 Continental Induction G5, Руководство пользователя и инструкции по установке и обслуживанию

Страница: 16 / 36

16
each side in turn, support the side rail and
press the frame down in to the side rails.
Replace the grill pan.
Control Panel and Oven Doors
For best results, diluted liquid detergents
should be used.
The control panel and control knobs should
only be cleaned with a soft cloth wrung out in
clean hot soapy water - but take care that no
surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with
a dry cloth. The oven doors should only be
cleaned with a soft cloth wrung out in clean
hot soapy water.
Cleaning Brass Components
Uncoated natural brass is used as part of the
authentic finish and may tarnish with age.
To regain a polished finish, these areas should
be cleaned using a proprietary cleaner such
as Brasso. Stubborn marks on the aluminium
burner rings can be removed using a similar
cleaning material. This will also restore the
polished finish.
Ovens
The shelf supports on the oven sides can be
removed for cleaning.
First remove the oven shelves then pull the
top of the shelf support up and away from the
oven side and then lift the support away from
the locating bracket in the oven side at the
bottom.
To refit the side support, first
locate the tag at the bottom
of the support in the slot in
the locating bracket in the
oven side.
Then locate the tops of the
side arms in the holes at the
top.
The panels on the oven sides are fixed and
cannot be removed. They have been coated
with special enamel that partly cleans itself.
This does not stop all marks on the lining, but
helps to reduce the amount of manual cleaning
needed.
The Cook & Clean panels work better above
200°C. If you do most of your cooking below
this temperature, occasionally remove the shelf
supports and wipe the panels with a lint free
cloth and hot soapy water. The panels should
then be dried and the oven heated at 200°C
for about one hour. This will ensure the Cook &
Clean panels are working effectively.
Don’t use steel wool (or any other materials
that will scratch the surface). Don’t use oven
cleaning pads.
Moving your cooker
Switch off the electricity supply.
The cooker is heavy; two people may be
required to move it.
The cooker is fitted with one roller at the front
and two at the back. There are also two screw-
down levelling feet at the front.
The front roller, designed for moving the
cooker, can be wound down. The levelling
tool that controls this roller should be in the
storage drawer compartment. If you cannot
find the levelling tool, contact your installer.
See the start of the ‘Installation’ section of these
instructions, where they should have entered
their details.