12.
Also at this point before you lace the Rear Window to the door you should wrap a 6” strip of adhesive
Velcro to the roll cage a little less than halfway up the rear bar. Then wrap the double-sided strip with
the strap sewn to it around the adhesive strip with the webbing strap facing the top of the vehicle. This
will be for holding the Soft Top in place later. The photo below shows how this should look.
13.
Now take the two 70” cords and lace the Door Panel to the Rear window as you would a pair of shoes.
Run the cord through the top holes from the inside out so that you have two equal length pieces coming
out of each hole. Then lace the cording down the remaining holes to the bottom and tie them off cutting
off any remaining cord. Be sure to melt the ends to prevent fraying. The photo below show how this
should look.
14.
Now time to install the roof panel. Included in your package are two sets of webbing straps. One set
has grommet holes in one end and these are used for the front of the top. The other set has double-sided
Velcro sewn to one end and is used for the rear of the top.
