NAVI-1/NAVI-XT VERSION
1.06
5 Operation
Guide
Before using the NAVI-1, make sure to prepare the following items:
♦
GPS software is properly installed on your Bluetooth™-enabled
device (PC, laptop, Pocked PC, or other handheld devices).
♦
The Bluetooth™ GPS Receiver is fully powered (i.e. internal
battery is full charged) and operational.
♦
Check that the Bluetooth™ GPS Receiver is ON.
This section will outline the necessary procedures for the Bluetooth™ GPS
receiver to run smoothly with the GPS Mapping software.
5.1 Installation
instructions
In the delivery package the FAL 700/3.7 battery for NAVI-1 is separately
packed, just take it out from its package, open the cover cap on the
underside of the NAVI-1 and insert the FAL 700/3.7 in it. The four contact
pads of the NAVI-1 and battery have to be in the same direction and
opposite to each other, finally close the cover cap. In order to recharge the
battery one of the aforementioned adapters has to be used. Place your
Falcom NAVI-1 in a location (e.g. vehicle’s dashboard) and turn it on by
pressing for approx. two seconds the On/Off button. In order to turn it off
again, press for approx. 2 seconds the same button. Thereby, a short acoustic
signal (peep) will each time be generated.
The position of the NAVI-1 mounting is crucial for its optimal performance.
Place the NAVI-1 in a way that the receiving side of the internal GPS
antenna which is placed on the top of NAVI-1 to have direct view to the sky
The Bluetooth™ connection between the Falcom NAVI-1 receiver and your
mobile phone/PDA/PC or laptop has to be established.
The following information will be indicated via 3 corresponded LED’s on
the top side of NAVI-1.
1. Left LED (blue), Bluetooth™ optical indicator:
Blinking, the equipment is ready for a Bluetooth™ connection.
Continually light, the connection between devices is created and
ready for use.
2. Middle LED (red/green), State of charge optical indicator:
Continually red, the equipment is switched on and the internal
battery is fully charged.
Blinking red, the voltage of internal battery is under 3.5 V, you
have to recharge it.
Continually green, the internal battery is in charging phase and the
equipment is switched off.
Green off (connected to power charger), the internal battery now is
completely charged.
3. Right LED (yellow), GPS optical indicator:
Blinking, the GPS-Mouse is searching for satellites
Continually light, the valid GPS data are being received.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 19
