FOX3-2G/3G/4G/-4G-PROMOTION-KIT Getting Started
Version 1.0.7
This confidential document is a property of FALCOM GmbH and may not be copied or circulated without previous permission.
Page 10 of 25
3.
Depending on the battery charge state, the charging time may by different but usually it takes 3-4
hours to fully charge the internal battery.
4.
After the battery is fully charged, unpack the USB to serial converter and the USB extension cable.
Remove the USB cover on the converter and connect the USB cable to the converter (1), see figure
below. Plug the serial port of the converter to the COM port of the control box (2). Finally, plug the
other end of the cable into a free USB port on your PC (3). This cable is used for communication
between the FOX3-2G/3G/4G and Workbench software for sending and receiving data as well as to
change the configuration stored in the FOX3/3G device.
Figure 6:
Connecting the converter with the USB cable
5.
Finally, power up the FOX3-2G/3G/4G device by turning the “
IGN
”-switch to "
ON
" position.
Figure 7:
Overview of the control-box top panel (IGN = ON)
“
+IN
”
It supplies power to the control box and FOX3-2G/3G/4G.
“
IGN
”
It turns on the FOX3-2G/3G/4G (wakes it up from the IGN sleep mode).
6.
If you want to use the FOX3-2G/3G/4G with external antenna, remove first power from the device,
unpack the supplied antenna and connect both ends of the antenna to the same colours of FAKRA
connectors on the FOX3/3G and power up the device again.
Figure 8:
Connecting the external antenna