LAGOON
GB
22
• Especially metal materials may cause a short circuit or an electric shock, and then to
the risk of damage and fire.
• Never let the appliance fall off or get damaged in anyway during its transport or use.
• Keep the appliance away from any kind of heat source such as heater, radiator,
electric stove etc.
• Do not leave the appliance and its accessories nearby fire or heat source such as
candle etc. as it may cause danger.
• Do not let the appliance and its accessories expose to direct sunlight.
• Only use the original accessories supplied by the manufacturer.
• Have a qualified electrician and plumber mount the required electricity wiring and
water system in compliance with your appliance which has 7000W heating capacity.
• The electricity wiring should be a stable system and installed by a qualified
electrician.
• Electrical connection should be earthed.
• An antigron power cord which has at least 3x4 mm
²
section should be used in the
wiring system.
• Electrical installation and start-up of the appliance should be done by a qualified
technician.
• Make sure that the electric network that the device has been installed is in conformity
with the specifications on the device. ( AC 230V – 50Hz )
• Device should be connected to the fuse panel with 32 Amperes.
• Primarily water connections and then electrical connections should be made during
the installation.
• Cable, fasteners and electrical components should be isolated after installation
before the start-up.
• Insulated part of the power cord should be at least 5 cm in length in the unit.
• Before the installation of electrical connections, fuse should be switched off and the
power line should be discontinued.
• After the installation of the appliance is complete, the tap should be turned on to full
for 1 minute before the start-up.
• The suitability of the electricity grid is the responsibility of the consumer and the
installation should be made by a qualified electrician.
• The manufacturer is not responsible for any damages and personal injuries caused
by the usage of the device in electricity grids which are non-compliance with local
regulations.
• Make sure that power cord of the appliance is laid in a suitable route so as not to be
stepped on, squeezed or damaged.
• Electrical cords shouldn't be twisted excessively and routed on wet or hot ground and
they should be kept out of reach of children.
• Do not use the appliance in case its power cord is damaged and contact with the
authorized service.
• Do not use the appliance with voltage converter device.
• Do not leave the appliance on unattended while in use.
• When the appliance is not in use for a long time, switch off the fuse.
• Even though the appliance is turned off, it contains high voltage.
• The appliance should be mounted on the wall and should be used in a fixed position.
• Do not use the appliance nearby the flammable, combustible or explosive materials.
• Make sure that there is not any flammable or combustible material such as gasoline,
thinner, alcohol, paint etc. in the environment in which the appliance is used.
• Never open the cover and do not attempt to make changes to the device hardware.
• The appliance contains uninsulated hazardous voltage which can be in a
life-threatening level and cause an electric shock.
• The appliance cannot be installed to water main, it should only be connected to the
bathroom or to another suitable area and water outlet should not be blocked in any
way by attaching a tap or a valve.
• Do not install the instant water heater in areas with the possibility of freezing of water.
• Do not operate the appliance in case of freezing of water.
• The shower head should be located and used so as not to be in a location higher
than the bottom part of the device.
• There will be changes at the inlet water temperature according to seasonal
temperature.
• You can provide hot water at will by adjusting the water temperature step switch and
amount of the water inlet.
• Do not operate the devices which are over 1000W (such as oven, iron, washing
machine etc.) when the instant water heater is in use.
• Power supply of the instant water heater is disabled in case of insufficient water flow
or water cut.
• Power supply is switched on again when it reaches sufficient water flow.
• In case of water flow higher than 6 bar (600 kPa) it is recommended to install flow
converter regulator to cold water inlet of the instant water heater.
• The hoses or pipes which are directly connected to the system must be resistant to 6
bar operating flow.
• Contact to Authorized Service for any kind of malfunction, maintenance and spare
parts supply.
• The appliance must be used with the new hose-sets and old hose-sets should not be
reused.
• Do not use this appliance when the power cord is damaged, do not attempt to
replace the cable by yourself or allow unauthorized persons to repair it.
• Power cord of the appliance should be replaced with a suitable cable by an
authorized service or a qualified electrician.
• In case of malfunction or damage to the appliance, turn off the appliance and the
electrical fuse immediately.
• Do not use damaged appliances.
• Never open the cover, do not attempt to repair the appliance by yourself and do not
let the unauthorized persons access to it and always get in contact with the
authorized service.
Unpacking
Unpack the appliance and before starting to use it check for
damages and malfunctions. If there is any malfunction or damage
to the equipment, do not use the appliance and get in contact with
Fakir Authorized Service.
Scope of delivery
Electric water heater
Shower head
Hose
Operating manual
Service list
Safety Warnings
NOTICE!
Keep the packaging for storage and future
transports.
WARNING!
Repairs must be performed only by Fakir authorized
services (see authorized service list).
Improperly repaired appliances may pose a danger to
the user. Fakir Elektrikli Ev Aletleri Dış Tic A.Ş. will not
be responsible of any problem caused by repair or
maintenance made by other than Fakir Services.
WARNING!
Never use a defective appliance.
