7
EN
•
If you are using the appliance without
the comb, do no not press it against
your skin as it could cause cuts.
•
The appliance must not be exposed to
temperatures of below 0 ºC or over 35 ºC.
•
Do not expose the appliance to direct
sunlight.
• This appliance should not be used
by physically, sensorially or mentally
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance by
a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
• For greater protection, we recommend
installing a residual current device (RCD)
with an operational residual current not
exceeding 30 mA. Ask your installer for
advice.
•
Before using the hair cutter, you should
become familiar with its different parts
and accessories by studying the figures
carefully.
•
Before using it for the first time, check
that the mains voltage coincides with
the voltage indicated on the adapter.
•
Do not use the hair cutter on wet
surfaces, near a bath or shower or over
a washbasin with water in it.
•
Keep this appliance out of the reach of
children.
•
Disconnect the appliance before carrying
out any cleaning or maintenance
operations.
•
This appliance is designed for domestic
use only and must be used as described
in this manual.
•
Do not wind the cord around the
appliance.
•
Regularly check the state of the cord.
If it is damaged, contact an authorised
technical service.
1. DESCRIPTION OF PARTS
A.
Short spacer comb
B.
Long spacer comb
C.
Blade unit
D.
Cut length selector
E.
Cut level indicator
F.
Charge pilot light
G.
On/off switch
H.
Mains connection
I.
Blade oil
J.
Cleaning brush
K.
Comb
L.
Scissors
M.
Adapter
N.
Carrying case (MCP-41 C)
Interference suppression:
this appliance has
been interference-suppressed in accordance
with the interference-suppression directives.
Electromagnetic compatibility:
this
appliance has been suppressed in
accordance with the EMC (electromagnetic
compatibility) directives.
2. IMPORTANT WARNINGS
3. HOW TO CHARGE THE HAIR
CUTTER
•
With the On/Off switch turned to "0",
connect the appliance to the mains. The
battery will only be charged if the switch
is turned to "0" (Fig. 1)
•
The first time you charge the appliance,
leave it to charge for around 14 hours.
After that, 7 or 8 hours will be sufficient.
The indicator light (F) will come on while
it is being charged.
•
When the battery has been completely
charged, use the hair cutter without
connecting it to the mains, until the
battery runs down.
•
Only charge the appliance again when
you notice it is not working normally.
•
Battery autonomy is around 35 minutes,
but the battery will reach its maximum
efficiency after it has been charged and
discharged several times.
•
You may use the hair cutter connected
to the mains when the battery has run
down. If the appliance does not start
up when you plug it in, turn the switch
to stop position ("0") and charge the
battery for five minutes.
