V0703 - 10i / 20i - Installation/Operation - DRO operation - (9/29)
2.4.2.1 Absolute mode
Set the dro in absolute mode
Move the axis until the display reads [14.000] (B position) and drill the hole.
Move the axis until the display reads [37,000] (C position) and drill the hole.
Move the axis until the display reads [62,000] (D position) and drill the hole.
The displayed position value is always referred to the preset part zero
(datum).
2.4.2.2 Incremental mode
Set the dro in incremental mode. ABS LED off
First method:
Presetting incremental zero after each drill.
Starting at point A.
Move the axis until the display reads [14.000] (B position) and drill the hole.
Set the X axis to zero. See note.
Move the axis until the display reads [23,000] (C position) and drill the hole.
Sets the X axis to zero. See note.
Move the axis until the display reads [25,000] (D position) and drill the hole.
Note:
If installation parameter PAR11=1, just press the axis key, ([X]) in this case, to
zero the axis.
Second method:
Presetting the relative distance with respect to the next hole.
Starting at point A
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (B position) and drill the hole.
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (C position) and drill the hole.
Preset the relative distance to the next hole. See note.
Move the axis until the display reads [0.000] (D position) and drill the hole.
ABS
(B) [14.000]
(C) [37.000]
(D) [62.000]
“ABS” off
(B) [14.000]
(C) [23,000]
(D) [25,000]
-14
(B) [0.000]
-23
(C) 0.000
-25
(D) [0.000]
