Fagor Evo Advance, Инструкции по установке, использованию и обслуживанию

Страница: 45 / 80

45
5.1.17 Selecting the date and time (only C MOD.)
The date and time are displayed in the following format. D
1
D
2
/M
1
M
2
/Y
1
Y
2
H
1
H
2
/m
1
m
2
. To programme
the date and the time, proceed as follows:

With the machine switched off, press MENU for 5 seconds.

Scroll through the CONFIGURATION menu until reaching the DATE/TIME function, and
then press the MENU button .

Press the START button to go to the DATE/TIME menu .

The value D
1
starts to flash immediately.

Use the MENU button to set the required value. (This is always ascending).

Press START to confirm the value, and go to the next setting ( D
2
).

Enter all the values. When the last value ( m
2
) has been entered, the programming is
complete.

It is also possible to confirm the setting without reaching the last value, by pressing the
START button for 3 seconds.
5.1.18 Cleaning the machine at the end of the day
At the end of the day, the filters, wash distributors, rinse branches and other accessories must be
cleaned. This is necessary to prolong the service life of the machine. To ensure the efficient washing
of the dishes, the dishwasher must be perfectly clean and disinfected.
5.2 Useful tips
Read the useful tips listed below carefully to allow you to get the most out of your dishwasher.
5.2.1 Maintenance
Always clean the machine correctly to prolong the service life of the machine.

Remove any waste from the machine at the end of each day.

Do not use abrasive, corrosive or acid products, chlorine-based detergents, solvents or
petrol derivatives to clean the machine.

Do not use pressurised water to clean the machine.

Only wash tableware, glassware or kitchenware that has been used for human food.

Check that the wash distributors rotate correctly every day.

Check the salt, rinse aid and detergent levels at the start of each day.

Call the technical service twice a year to have the machine serviced:
o
Cleaning of water filter.
o
Cleaning of limescale on the resistors.
o
Inspection of the condition of the seals.
o
Inspection of the condition of the parts.
o
Adjustment of the dispensers.
o
Tightening of the electrical connections on the terminals.

If the power cable is damaged, it must be replaced by the manufacturer, after-sales service or
authorised technical personnel in order to prevent risks.
5.2.2 Rinse aid and detergent
If you change the rinse aid or detergent, the settings should be adjusted accordingly. This
adjustment must be carried out by qualified personnel. Only use detergents suitable for industrial
dishwashers. Do not use foam-producing detergents. Detergents designed for domestic use should
not be used under any circumstances.
When handling chemical substances, the safety instructions must be observed. Use
suitable protective clothing, gloves and safety goggles when handling chemical
substances. Do not mix different detergents.
5.2.3 Hygiene regulations

Do not touch clean dishes with dirty or greasy hands.

Use clean sterilised cloths to thoroughly dry the dishes.

We recommend you wait until the machine reaches the correct wash temperature as this will
ensure a more thorough disinfection and wash.

Drain the wash tub at least twice a day or every 40/50 wash cycles.