Fagor Evo Advance, Инструкции по установке, использованию и обслуживанию

Страница: 42 / 80

EN
42
5.1.4 Filling and heating
In the A models, when the machine is switched on, it will start to fill. First the rinse boiler is filled and
then the wash tub. The filling process may last a few minutes. Once the wash tub is full, the boiler
and the tub start to heat up. Although it is possible to start the wash process, this is not
recommended as the water inside the machine is not yet at the ideal temperature. When the
machine has reached the ideal temperature for washing the dishes properly, a light comes on,
advising the user that the machine is ready. The required temperature of the machine is 85
⁰
C / 185
⁰
F in the rinse boiler and 60
⁰
C / 140
⁰
F in the wash tub. It is recommended that the water in the
dishwasher is changed every 40/50 washes or twice a day.
In the B, C models, the filling is thermostatic. This means that when the water boiler is full, the boiler
heats the water to a temperature of 60
⁰
C / 140
⁰
F and then the tank is filled. This process is
repeated each time the boiler is emptied during the filling cycle. This filling system is more efficient
but it helps to reduce the electricity consumption as when the machine has been filled, the water is at
the correct temperature.
The hood must be closed for the machine to start filling. For safety reasons, if the
hood is open, the machine will not fill.
The machine you have purchased has a safety thermostat in the boiler and another for the tub, so
that in the event of the breakdown of any of the main thermostats, the safety thermostats switch off
the corresponding heating.
During the first heating of the day, the boiler may reach a higher temperature than
that mentioned above due to heating inertia. This is normal. If pressurised steam is
observed coming out of the rinse branch nozzles, while the boiler is heating, the
technical service should be notified.
5.1.5 Preparation of the dishes
Before washing the dishes, the preparatory steps below should be followed:

Remove the largest pieces of waste from the dishes before placing them in the baskets.

Wash glassware first.

Put the plates in the rack basket.

Place the glasses upside down.

Place the cutlery in the cutlery baskets with the handles downwards. The different pieces of
cutlery can be mixed.

Place the cutlery baskets in the lower baskets.
5.1.6 Selecting the wash cycle
Before starting the wash cycle, place the corresponding basket containing the dishes in the machine,
let the hood open. A wash cycle (C, D, E) must be selected in order to start the wash in the A, B
models. Each wash cycle corresponds to a wash time (55 s/75 s/120 s), that should be selected
according to the user requirements. Close the hood and the wash cycle will start automatically.
In the C models, to start the wash process, select the wash cycle you wish to run by pressing button
O Programme selector switch. Each wash cycle (60 s/90 s/180 s/90 s) corresponds to a wash time
that should be selected according to the user requirements. Then press button Q START cycle
button.
The hood must be closed for the machine to start the wash cycle. For safety
reasons, if the hood is open, the wash cycle will not start.
5.1.7 Thermo-stop (only B MOD.)
The thermo-stop is designed to ensure a constant rinse at the maximum temperature. This means
that the machine continues washing until the boiler reaches the ideal temperature. Then the rinse
cycle starts.
If the mains water temperature is less than 50
⁰
C / 122
⁰
F, the installation of this
system may reduce the wash capacity of the glass washer.