Fagor CNC 8055i, Руководство по установке

Страница: 57 / 732

Installation manual
CNC 8055
CNC 8055i
80
55 CNC CONFIGU
RATION
1.
S
OFT
: V02.2
X
·57·
C
e
nt
ra
l un
it
1.2.4 –I/O– module (inputs - outputs)
This module is used to expand the basic configuration and may be used to expand the number of
digital inputs and outputs of the PLC.
Each module provides:
64 Optocoupled digital inputs.
32 Optocoupled digital outputs.
The numbering of the various inputs and outputs of each module depends on the logic address
assigned to the module and it is as follows:
The PLC can control up to 512 inputs and 512 outputs although it can only communicate to the
outside world through the ones indicated above.
Module Inputs Outputs
–Vpp Axes– module
–Vpp SB Axes– module I1-I40 O1-O24
Input - output module I/O (1) I65-I128 O33-O64
Input - output module I/O (2) I129-I192 O65-O96
Input - output module I/O (3) I193-I256 O97-O128
Do not manipulate the inside of the unit. Only personnel authorized by Fagor Automation may access
the interior of this unit.
Do not handle the connectors with the unit connected to AC power. Before manipulating these
connectors, make sure that the unit is not connected to main AC power.
The machine manufacturer must comply with the "EN 60204-1 (IEC-204-1)", standard regarding
protection against electrical shock due to I/O contact failures with external power supply when not
hooking up this connector before turning the power supply on.