14
To switch off the system, re-press the same two
buttons: after 3 seconds LED 5 will stop flashing
and the device will be switched off.
6 - Intensive speed LED
7 - Intensive speed ON switch
This speed should be used when the
concentration of cooking fumes or odours
is particularly strong (for example when
frying, cooking fish etc.). The fast speed
will run for about 5 minutes and then
return to the speed previously set
automatically (1, 2 or 3), or switch off if no
speed was selected. To turn off the fast
speed, before the end of the 5 minutes,
press button 1 or button 2.
8 - OFF lamp button
9 - ON lamp button
If the hood fails to operate correctly, briefly
disconnect it from the mains power supply for
almost 5 sec. by pulling out the plug. Then plug it
in again and try once more before contacting the
Technical Assistance Service.
Warning!
— This appliance is designed to be operated by
adults. Children should not be allowed to
tamper with the controls or play with the
appliance .
— The hood cannot be connected to flues of
other appliances that run on energy sources
other than electricity.
— When the hood is used at the same time of
other appliances that run on energy sources
other than electricity, provision must be made
for an adequate supply of air.
— No food must be cooked flambé underneath
the hood.
The use of an unprotected flame is dangerous
for the filters and could cause fires.
Therefore, never use an open flame under the
hood. When frying foods, never leave the pan
alone because the cooking oil could flare up.
— Please, keep to the provisions of official
directives regarding the question of fume
discharge.
— The manufacturers refuse to accept any
responsibility for damage to the hood or its
catching on fire because of failure to observe
the above instructions.
Maintenance
Before performing any maintenance operation,
isolate the hood from the electrical supply by
switching off at the connector and removing the
connector fuse.
Or if the appliance has been connected through
a plug and socket, then the plug must be removed
from the socket.
Metal grease filter (2 or 3 pieces)
The metal grease filter lasts forever and must be
washed either by hand or in the dishwasher
(65°C) with suitable detergents.
When washed in a dish washer, the grease filter
may discolour slightly, but this does not affect its
filtering capacity.
The metal grease filters must be washed at least
once a month and anyhow whenever the LED 4
indicates the saturation of the filter (see
page 13).
This LED flashes to warn you that the metal
grease filters must be cleaned.
Generally, these must be cleaned after 40 hours
of use.
Once the grease filters have been cleaned, press
button 1 for about3 seconds until you hear the
acoustic signal (beep): the LED 4 will now stop
flashing.
Remove the filter using the handles designed
for this purpose by pulling the filter backwards
and then downwards (Fig. 1).
Let the filter dry without damaging it before putting
it back into place.
Carry out the above steps in reverse order to put
the filters back after having washed them.
Carbon filter (2 pieces)
This filter dissolves cooking odours.
The carbon filter must never be washed.
The carbon filter should be replaced every 4
months under normal use and anyhow whenever
LED 5 indicates the saturation of the filter
(see page 13).
This LED flashes to warn you that the carbon filter
must be replaced.
This must be done after approximately 160 hours
of use.
Once you have replaced the carbon filter, press
button 1 for about 3 seconds until you hear the
acoustic signal (beep).
The LED 5 will now stop flashing.
GB
