EN
24
sensor setting.
Refit the door carrying out the removal steps in
6.
the reverse order.
NOTE !
1. Do not use detergents or soap for cleaning ca-
talytic enamel shields, as this can damage the
enamel.
2. Use special oven cleaning agents to clean
the enamelled surfaces but not the catalytic
shields.
In cookers after washing the inside of the oven mo-
unt the side catalytic shields
5
(fig. 10.2.1), the gu
-
ides and the oven door.
NOTE !
Before proceeding with the troubleshooting, di-
sconnect the cooker from the power supply to
avoid being electrocuted.
In the warranty period all repairs except for the
•
ones specified below should be carried out by the
authorised Servicing Point.
If there are some disturbances during the use of
•
the appliance, follow the guidelines below to check
if you can repair the defect yourself.
Problem
Solution
Igniters fail to ignite or not always ignite
the gas
Check to make sure the cooker is connected to the electrical mains.
–
Clean and dry the igniters and burner components.
–
Check to make sure the burner caps and heads are placed correctly.
–
Press on the burner cap and rub it against the head by turning right
–
and left (fig. 12.1.1).
Rub the igniter electrode with the use of hard brush or smooth file (fig.
–
12.1.2).
Gas burners fail to ignite
Check to make sure the rubber hose supplying gas from the gas cylin-
–
der is not squeezed.
Check to make sure the gas main valve is open.
–
Check to make sure the gas cylinder is not empty.
–
In case a new cooker has been installed or the gas cylinder has been
–
replaced with a new one, then it is necessary to repeat the ignition
procedure until the gas reaches the burner.
Check to make sure the nozzle or burner flame holes are not clogged
–
or flooded. If so, un-clog the nozzle hole using a pin or needle. Clean
the burner flame holes with the use of brush, and then dry all compo
-
nents.
Flame dies after releasing the knob
Your cooker is equipped with a flame failure safety device
Where the ignition device is built in the knob set the
–
knob to large fla
-
me , press the knob and when the gas has ignited keep it pressed
all the way in
for another few seconds. .
–
Where the ignition device is activated by the button, set the knob to
large flame
and keep it pressed all the way in, press the ignition
button and when the gas has ignited keep the knob pressed
all the
way in
for another few seconds.
While igniting one of the burners all the
hob burner igniters spark
It is normal
When pressing the selected knob (with a built-in ignition device) or the
ignition button sparks are re-leased at all the burners .
After setting the knob to simmering flame
position
- the flame dies or is too high
Avoid draughts in the kitchen,
–
Call the fitter to adjust simmering flame position
–
.
12.1.1 12.1.2
Содержание CFF 1064GC
Страница 2: ...1 1 1 1 6 4 1 6 6 1 6 6 2 CFF 1054CX CFF 1064GC CFF 1064GCX 2 6 1 ...
Страница 27: ...EN 26 ...
Страница 28: ...03 2010 C600931I0 ...
