97
Warning: Use only rinse aid designed for domestic dishwashers. Wipe up spilled rinse aid
with a cloth as it will cause the formation of large amounts of foam, and thus will reduce
the dishwashing effectiveness.
If the water hardness is higher than the maximum values given in the table above, or if you use water
from a deep well, it is recommended to use filters and water treatment equipment.
NOTE: The factory settings are for the water hardness level 3.
Water hardness table
Water hard-
ness
German
degrees
[dH]
French
degrees
[dF]
British
degrees
[dE]
Water hardness level indicator
Special salt
consumption
[g/cycle]
1
0 ~ 5
0 ~ 9
0 ~ 6
H1
0
2
6-11
10-20
7-14
H2
9
3
12-17
21-30
15-21
H3
12
4
18-22
31-40
22-28
H4
20
5
23-34
41-60
29-42
H5
30
6
35-55
61-98
43-69
H6
60
The use of detergents
Use a detergent for domestic dishwashers. On
the market you can find detergent intended for
dishwashers in the form of powder, gel and tablets.
The detergent must be placed in the dispenser
before starting the dishwasher. Store detergent in a
cool and dry place, out of reach of children.
Do not overfill the detergent dispenser, otherwise
the detergent may not dissolve completely and
leave streaks on the dishes.
If you need more information on the detergent
used, please contact the manufacturer directly.
1. Switch on the appliance;
2. Press the Program button for more than 5 se-
conds to start the water softener set
model within 60seconds after the appliance was
switched on;
3. Press the Program button to select the proper
set according to your local environment, the sets
will change in the following sequence:
H1->H2->H3->H4->H5->H6;
4. Press the On/Off button to end the set up model.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed to adjust the
consumption by user. Follow the below steps.
1. Power on the dishwasher by plugging in, and press the Power botton;
2. Within 60 seconds after step 1, press the Program button more than 5 seconds, and then press the
Delay button to enter the set model, the rinse aid indication blinks as 1Hz frequency.
3. Press the Program button to select the proper set according to your using habits , the sets will change
in the following sequence: D1->D2->D3->D4->D5->D1.
The higher the number, the more rinse aid the dishwasher uses.
4. Without operation in 5 seconds or press the Power button to exit the set model, the set success.
