fafnir VISY-Input 8, Техническая документация инструкция

Страница: 7 / 12

Configuration Page 5/9
For the wiring of VISY-Input 8 with VISY-ICI 485 it is recommended using a 3-core cable with
signal ground (GND connection terminal) to increase the noise immunity.
Figure 4: Communication screw terminal
Additional information about the connection of the communication line can be found in the
documentation of VISY-ICI 485, see:
• Technical Documentation VISY-ICI 485, art. no. 207150
3 Configuration
For VISY-Input 8 the function of each input must be set by inserting or removing the corre-
sponding jumper (see section 2.6).
Further configuration of VISY-Input 8 is done - as usual for the VISY-X system - with the con-
figuration software VISY-Setup.
Wired version of the VISY-X system:
If VISY-Input 8 is used with the wired version of the VISY-X system, the data
protocol for communication with the VISY-Stick must be set to “Multi Probe”
using the VISY-Setup. Due to the shorter communication times, “Multi Probe
4800 bps” should preferably be used.
Wireless version of the VISY-X system:
If VISY-Input 8 is used with the wireless version of the VISY-X system, the data
protocol for communication with the VISY-Stick must be set to “Standard VISY
TLG“.
Please follow the appropriate instructions in the VISY-Setup manual.
• Technical Documentation VISY-Setup V4, art. no. 207158
After the configuration it should be tested whether the alarm signalling
works as expected.
GND A B