ADJUSTMENT OF THE LIMIT SWITCHES
1°
Bayt 980
left version
1
2
3
10
11
TIGHTEN THE
COUNTER NUTS
1.
Flexible limit switch
lever
2.
L.S. adjustable ridged
feelers
3.
M6
Counter nut
in its two positions
Sx
Important:
At the moment of test inspection in the factory
the position of the two feelers was already
correctly adjusted with the position of the
barrier beam in opening and closing vertical and
horizontal respectively.
Once the procedure on the stop points of the Bayt 980 barrier beam has been finished, it is possible to adjust the
opening and closing limit switches with the “
L.S.” adjustable ridged feelers
, which contact the flexible limit switch
lever. After having verified the correct operation of the flexible lever (both in vertical and in horizontal) on the
limit switch system micro-switch, it is necessary to securely tighten the single counter nuts (Fig. 26).
FIG. 26
ORDINARY MAINTENANCE
Sx
3°
2°
GREASE
Sx
It is recommended that the following units be
“GREASED”
every three months with the specific greaser:
1
st
- Central barrier beam actuation shaft Bayt 980.
2
nd
- Upper attachment pin for the barrier beam command
rod-yoke-connecting rod.
3
rd
- Lower attachment pin yoke-reservoir-piston Cos 982.
"GREASE"
every three months
!
FIG. 27
Periodically it is necessary to perform maintenance to the Bayt 980 barrier, injecting grease by way
of suitable
greasers
(Fig. 27).
For optimum performance of the system over time according to safety regulations, it is necessary to perform proper maintenance and monitoring of the
entire installation (for the automation, the electronic equipment installed and for the cabling connected to these). Only qualified technical personnel must
perform the entire installation, filling out the Maintenance Manual indicated in the specific Regulation Book (to be requested):
- Hydraulic mechanism: maintenance inspection check at least every 6 months;
- Electronic equipment and safety systems: inspection check at least once every month;
- Ordinary and extraordinary maintenance must be agreed on between the principal and the maintenance firm.
- Dispose of the packaging containers, such as the cardboard, plastic sheeting, foam padding, etc., through specialised waste disposal firms.
DO NOT DISPOSE OF EITHER WASTE OR TOXIC SUBSTANCES INTO THE ENVIRONMENT.
- In the event of the removal of the "Cos 982" Actuator,
do not cut the electrical wires
, but remove them from the terminal loosening the setscrews in the
derivation box.
!
"L.S."
!
Bayt 980
page
14
Made in Italy
the gate opener