Factron QHC24MR, Быстрый старт

Страница: 6 / 8

Pairing (programming) devices
QHVCR & QHC24MR
Pairing (programming) devices QHVCR (transmitter) and QHC24MR (receivers).
1) The Left Hand Side rotary switches (TEN) on both boards must be set the same.
The LHS switch (TEN) is used to set the RF frequency the setting must match on both
boards. There are 10 possible frequencies that can be selected 0-9 . If the settings on the LHS
switch (TEN) do not match the devices will fail to operate.
Designating the transmitter and receiver. Both the left rotary switches are set at 0 ,
this ensures that the transmitter marked 0 will communicate with the receiver marked 0 .
Setting the left rotary switch to 1 , so the transmitter marked 1 will communicate with a
receiver also marked 1 .
If the transmitter and receiver are not paired correctly they will not communicate and
therefore will not operate; transmitter marked 0 will not communicate with a
receiver marked 1.
Remember a transmitter can be set at any number between 0-9 & the receiver must be
matched correctly.
2) The Right Hand Side rotary switches (UNIT) are for setting the devise to operate in a set
zone. There are 3 possible zones that the controller can be set to. The RHS switch (UNIT)
should be set to 1,2 or 3.
Blue
Zone 1 operation set RHS switch (UNIT) to 1
Yellow
Zone 2 operation set RHS switch (UNIT) to 2
Red
Zone 3 operation set RHS switch (UNIT) to 3
Page 5