QHVCR remote Master Controller (transmitter)
1) There are three control dials Blue, Yellow & Red one for each zone. The QHCxxMR units are
preset to operate in one of these zones. The QHCxxMR unit once preset will only operate in that
designated zone. The factory setting is 1, this will be the Blue control dial.
2) Turn ON the QHVCR unit by pressing the ON/Standby button on the front panel. The Led
indicator will flash orange – green – orange – green and remain Green to indicate that the unit is
ready.
3) The QHCxxMR unit is preset as a Blue zone (1). Turn the Blue control dial to position
2
. The
heaters connected to the QHC06MR units will come ON at the minimum setting 33%. Continue to
turn the Blue control dial through position 3 to 5 until you reach the desired setting. Settings are
1
=
0%,
2
= 33%,
3
= 50%,
4
= 66% &
5
= 100%.
4) QHCxxMR units which are preset to Yellow & Red zones are controlled by the Yellow & Red
control knobs respectively and will operate as above in 10).
5) The QHVCR unit is powered by 3 x AAA battery's. So, the unit will automatically go into standby
mode if the unit is inactive for more than 30 seconds. When the unit goes into standby mode all the
QHCxxMR units will remain unchanged at the settings they were set at. The heaters will remain ON.
6) To change a setting just press the ON/Standby button and proceed as described in 9) & 10).
However, while the QHVCR unit is ON, you can turn OFF all the heaters by pressing the ON/Standby
button. This is indicated by the Led indicator flashing Red.
7) The previous settings will be remembered and will be restored when you press the ON/Stand by
button again.
Please note:
The QHVCR remote Master Controller can control any number of
QHCxxMR controllers as long as they are within range, up to 100 meters *
(see specification sheet for the QHVCR unit).
The QHVCR should be wall mounted.
Page 4
Содержание QHC24MR
Страница 7: ...Page 6...
