Factory Cat Pilot 28'' DISK, Руководство по эксплуатации

Страница: 18 / 41

- 18 - PILOT-OP-EN
MACHINE OPERATION
PRE-CLEANING CHECKLIST:
Read and understand the complete Operator’s Manual
before operating the machine along with fi lling out and
sending in a Machine Installation Form.
1. Check Battery Gauge on the Control Panel. Make
sure Batteries are fully charged before using.
2. Check the condition of the Pads or Brushes.
3. Check the condition of the Squeegee Blades.
4. Raise the Scrubdeck and Squeegee before
transporting then transport the machine to the fi lling
station.
5. Turn the machine OFF ( ). Remove key.
6. Fill the Tank with up to 23 gallons of clean water either
at the fi ll port (A) (SEE BELOW) .
7. Add APPROVED cleaning chemical to the Tank.
Use the proper dilution ratio indicated on the bottle.
Contact us at 1(800)-634-4060 or +001-262-681-3583
if unsure.
NOTICE
The clear tube (Solution Sight Tube) (B) at the front and
rear of the machine indicates the amount of water in the
Tank
(SEE BELOW) .
DANGER
EXPLOSION RISK! Flammable materials can cause an
explosion or fi re. Do NOT use fl ammable materials in
Tank or pick up.
CAUTION
TO AVOID DAMAGE TO THIS MACHINE:
•
Use APPROVED detergents only
•
Water temperature must not exceed 130˚F/54˚C
•
Do NOT use high-percentage Bleach mixture
OPERATING HINTS:
1. Observe the amount of solution the machine is
dispensing on the fl oor and adjust to the desired fl ow.
To increase the solution fl ow rate, press the Solution
Control Lever forward. To shut the solution
OFF ( )
completely, just release the Foot Pedal, or use dash
mounted solution switch
ON ( ) / OFF ( ).
2. Keep an eye on the clear Vacuum cover to make sure
that there is not any foamy buildup in the Recovery
Tank. If excess foam begins to develop, stop and drain
tank and pour a recommended foam control solution
into the Recovery Tank. Foam is usually an indication
of excessive soap.
3. Always operate on fl at, solid surfaces at lower speeds
when scrubbing around walls and objects. You should
reduce the speed to maintain control when turning.
Don’t operate on ramps or incline.
4. If Squeegee starts to streak, raise and wipe the Blades
with a clean cloth. If the problem continues, check the
Squeegee Hose for clogs and the Squeegee Blades
for wear or damage and rotate if needed. You may
need to pre-sweep before scrubbing.
(Only Use OEM
Parts)
5. Change or turn over Brushes / Pads when dirty.
6. Stay clear of objects protruding from the fl oor such as
sockets, grates, etc, for they will damage the Brushes /
Pads and Squeegee Blades.
7. Always keep an eye on your gauges. They let you
know the status of a particular system at a glance.
If your battery gauge is reading low you must stop
immediately and recharge. Running the Batteries
dead will result in permanent damage to the Batteries.
8. When you run out of solution, raise the Scrubdeck and
continue to Vacuum the remaining water until it is all
consumed. The Solution Sight Tube is used to indicate
the level of detergent remaining in the Tank.
9. When you are ready to stop, raise the Scrubdeck, turn
OFF ( ) the solution switch, raise the Squeegee and
drive the machine back to the charging area. Be sure
to drain both Tanks before storing the machine and
store with key removed and seat in the up position.
A
B
B