1-4
Place the battery holders around the Di2 battery. The
male shell grooves must match with the female battery
groove.
1-5
Insert battery into seatpost
1-6
Insert the seat post clamp into the frame. Note: you may find it
easier to keep this from falling down into the frame if you coat it
in carbon prep compound, and/or tilt the frame downwards
1-7
Apply Black Inc Installation Compound to the inside of
the seat tube. Connect the Di2 cable to the battery.
Insert seat post into the frame to the desired height.
1-8
Secure the seat post by carefully tightening the grub
screw to
8Nm
Note:
Your Factor frame set requires a minimum of 90
mm of seat post insertion. The minimum insertion is
clearly marked on the seat post. Failure to achieve the
minimum insertion could cause damage to the seat
post or frame resulting in serious injury or death.
