Facnor - Installation manual rev 2012 – LS+/LX+/RX+ reefing and furling systems
4- ASSEMBLY STAGES :
4.1 – ASSEMBLY OF THE HALYARD DEFLECTOR*
Slip the disk around the forestay, screw pointing up.
Assemble the two half bushings
above
the deflector disk
and around the forestay, the “female” part pointing up.
Fit the bushing into the halyard deflector. Then tighten the
screw (fig. F), which will fix the bushing in place.
*N LS/LX330 models, the halyard deflector wheel has been
replaced by a block diverting the halyard and this is to be riveted
onto the mast (see page p29 for further explanations).
4.2- ASSEMBLY OF THE TOP CAP AND THE TOP SECTION
4.2.1
4.2.2
4.2.3
4.2.4
Slip the stainless
steel plate and then
the top cap around
the forestay.
Position the plate
by slipping it into
the notches on the
cap, designed for
this purpose.
Around the forestay ,
assemble a first
bushing, then a
second one, the
“male” part pointing
up. Fit the bushing
together, and give
the bottom bushing a
quarter trun.
Those two
bushings are
now joined.
Put the bushing set
into the cap, give
another quarter
turn to the
bushings.
Doing this
ensures that the
bushings are
fixed in place in
the top.
Take the top section
and fix it snugly into
the top cap. If
assembly is not
possible, give the
bushings a half turn in
the cap.
Place the two pins into
the holes in the top
cap and the stainless
steel plate. The, tap
them into the section
groove with a mallet.
The pins are simply used to fix the cap. Therefore, do not hit too hard or you
may damage the cap.
23
English
top
memale part
F
male
part
1/4
1/4
1/4
1/4
top
top
top
top
top
top
top
top
male
part
