Page
16
with
33
Page
16
with
33
Page
16
with
33
Page
16
with
33
MANUAL - WELDER Fantasy PULSE BI-201
1.0mm wire
Step 3 Select the diameter of welding wire
The user selects the diameter of welding wire, which it
plans to use.
ATTENTION!
Device
automatically
decreases
or increase its maximum power depending on the
diameter of the wire.
1.2mm wire
Step 3 Select the diameter of welding wire
The user selects the diameter of welding wire, which it
plans to use.
ATTENTION!
Device
automatically
decreases
or increase its maximum power depending on the
diameter of the wire.
According to the adopted values of the welding parameters in software user-selected diameter of the welding wire has
a direct impact on the current and welding voltage and wire feed speed. For example, the choice of wire with a
diameter of 0.8 mm will automatically limit the maximum welding current for example. 140A, the selection of wire
1,0mm allow welding current of 200A. These activities aim to optimize the welding process and avoid the problems
associated with too fast of burning wire just behind the tip in the current situation where there is no further possibility of
increasing the speed of the feeder.
Inability to set the maximum welding current is not a software error and results from selected diameter
welding wire.
Содержание WELDER FANTASY BI-PULSE 201
Страница 1: ...ORIGINAL INSTRUCTIONS 2019 MANUAL WELDING ...
