Fac C3, Руководство по эксплуатации и обслуживанию

Страница: 32 / 45

30
EN
MOTOR BELT TENSION ADJUSTMENT
Whenever the cutter makes an unusual noise after a certain period of time,
which is due to settling of the belt (30), it may be necessary to adjust tensioning.
Operate as follows:
☞
Do not over-tighten the belt.
In the rotation, the engine could force and the
belt may be damaged.
• Disconnect the plug from the socket.
• Remove the pot (5) from the body of the appliance (1) as described
previously;
• Lift the cutter.
☞
Make sure that the cutter is stable and can not
inadvertently fall.
• For “ C3 ” model only (Fig. 16):
- Unscrew all 4 feet (2) and the screw (v) under the base; remove the cover
(2b).
- Loosen the nut (13) and the screw (10), adjust the belt tensioner (12).
- When the operation has been completed, tighten the nut (13) and the screw
(10).
• For “
C5
” and “
C8
” models only (Fig. 17):
- Unscrew all 4 feet (2) and the screw (v) under the base; remove the cover
(2b).
- Loosen the screws(13), interact with the two nuts (15) to tension the belt.
- When the operation has been completed, tighten the screw (13).
Only for personnel authorized by the manufacturer