•
TORQUE WRENCH
•
MIG WELDER
•
COIL SPRING COMPRESSOR
FRONT SUSPENSION INSTRUCTIONS:
1.
Disconnect the negative terminal on the battery. With the
vehicle on level ground, set the emergency brake and block
the rear tires. Jack up the front end of the truck and support
the frame rails with jack stands.
NEVER WORK UNDER
AN UNSUPPORTED VEHICLE!
Remove the front tires.
2.
Working from both sides of the truck, locate and remove the
factory skid plate and brackets. Discard skid plate and
hardware, these will not be reinstalled on the truck. SEE
PHOTO BELOW.
3.
Remove factory mud flaps off front of the vehicle and discard.
4.
Remove the nut from the tie rod ends. Disconnect the tie rod
ends from the steering knuckle by striking the knuckle with a
large hammer to dislodge the tie rod end.
Use care as to not
hit the threads on the tie rod end with the hammer as you
will damage them.
Save all hardware. SEE PHOTO BELOW
5.
Remove the sway bar end links from the factory steering
knuckles and leave connected to the bar. Then remove the bar
from the truck. Save the bar and end links with all hardware.
SEE PHOTOS BELOW.
