30.
Torque factory control arm pocket bolts to 100 ft lbs., the ¾”
front crossmember bolts to 110 ft. lbs., the 9/16” rear
crossmember bolts to 100 ft. lbs., the ½” differential mounts
to 75 ft. lbs., the ½” skid plate bolt to 75 ft. lbs., and the 5/16”
skid plate bolts to 20 ft. lbs.
31.
Locate the factory brake line tab next to upper control arm.
Unbolt the bracket from the frame save hardware and bracket.
You will need to carefully pull the hard brake line down 4”.
Locate FT70061 brake line drop bracket and attach the
bracket to the frame with the factory hardware in the upside
down J formation. Attach factory bracket to the new bracket
using the supplied 5/16” x 1” bolt, nut, and washers. SEE
PHOTO BELOW.
32.
Locate FT70063 & FT70064 (drv. / pass.) spindle brake line
bracket. Attach to the Fabtech knuckle using the supplied ¼’
x ¾” bolts, washers, and split washers. Attach the factory
bracket to the new brake line bracket using the supplied ¼” x
¾” bolt, washer, & split washer. SEE PHOTOS AND
DIAGRAM IN THE NEXT COLUMN AND PAGE
FT70061 Drop Bracket
