35.
Locate FT70100 Driver Sway Bar Drop Bracket, FT70101
Pass. Sway Bar Drop Bracket and the factory sway bar, with
hardware. Also locate the supplied 3/8” x 1 ¼” hardware.
Position the new drop bracket on the frame so the sway bar
will be mounted forward of its factory position and attach
with the factory hardware. Use a paint pen or center punch
and mark the core support / frame at the front tab of the drop
bracket. Use a drill with a ½” bit and drill a hole into the
support. Locate FT70106 Sway Bar Bracket Nut Tab and the
supplied 3/8”x 1 ¼” bolt, flat washer, and split washer. Insert
the nut tab into the frame and attach with the 3/8” hardware.
SEE PHOTO BELOW
36.
Install the sway bar to the new drop brackets with the
supplied 3/8” hardware.
(the sway bar will need to be
mounted upside down from the factory position).
SEE
PHOTO IN NEXT COLUMN
Front of truck
Driver side shown
37.
Locate FT70105 Sway Bar End Link, FT95023 ½” Heims,
and supplied ½” Jam Nuts. Thread the jam nuts all the way
onto the heims. Insert an assembled heim into each end of the
end links and leave loose. Locate FT70102 (sway bar hat) and
FT70103 (low profile mis-alignment) and the supplied 3/8” x
2 ¼” hardware. Insert the hat and low pro mis-alignment into
the heim on one end and attach to the sway bar. Locate
FT95020 or FT70159 misalignments and the supplied 3/8” x
3” hardware. Insert the mis-alignments into the upper heim
and attach it to the Fabtech steering knuckle. Torque the 3/8”
hardware to 30 ft. lbs. SEE DRAWING BELOW AND
PHOTOS ON NEXT PAGE
FT70106
Nut Tab
FT95020
Mis-
Alignment
