Insert
clutch end
Clutch end with
pin locked
into place
Installing chain guard, with chain
inside
of the chain guard
(1) LOWER SHADE TO DESIRED
LONG POINT. PINCH THE
BEAD CHAIN AS SHOWN.
(3) CLOSE THE BEAD CHAIN STOP.
(2) PLACE BEAD CHAIN STOP HERE.
(4) YOU ARE DONE!
Installation steps 1 to 4 for the stop position.
STEP 2 - INSTALLING THE SHADE
(continued).
c. Slip the clutch end into the bracket.
While keeping the idler end in position, lift the shade up
into the bracket and align the clutch end pin into the
middle of the cross shaped hole.
Gently slide in place and pull down to lock in place.
STEP 3 - ATTACH THE CHAIN GUARD
.
Note: A small magnetic tip Phillips screwdriver is ideal for this
step, as the screws must slip through the holes inside the
chain guard before attaching to the bracket. Make sure the
chain itself is to the
inside
of the chain guard.
d. Slip the transit clip back onto the idler end. The transit clip
locks the spring-loaded idler end of a roller shade, so that
it cannot retract. It also prevents the roller shade from
slippping out of its brackets during shipment.
STEP 4 - SET THE STOP POSITION.
Lower the shade to the desired long point.
Then pinch the bead chain at this point and place one of
the bead chain stops here. One extra bead chain stop is
provided in case a change must be made.
