7
EN
6
EN
5. OPERATION
IMPORTANT: REMOVE THE CARDBORD LINER
The cardboard liner secured the fuel effect in place while the
product was transported and should be removed after installation.
Retain the cardboard liner, this must be refitted in the event of
transporting the appliance. Follow the following instructions.
ALMA
1. Open Ashpan Flap.
2. Lift window upwards and outwards.
3. Fold the top corners of the cardboard liner inwards and
remove.
4. Slide the fuel effect in towards the mirrored glass.
5. Fit the door glass.
OTHELLO
1. Open door.
2. Lift out cardboard liner.
3. Slide the fuel effect in towards the mirrored glass.
5
5..11 O
OP
PE
ER
RA
AT
TIIO
ON
N
VARDA/NARVIK/IVAR/ALMA
The controls are located behind the hinged
'ashpan' flap, control cover (fig. 11).
Connect the fire to your electricity supply.
OTHELLO
The controls are located on the top canopy
behind the door (fig. 12).
Connect the fire to your electricity supply.
4. INSTALLATION
(Varda/Narvik)
4.1 INSTALLATION INSTRUCTIONS
Have the stove installed by a qualified installer in conformance
with national and local (fire safety) regulations.
Be sure that the chimney functions properly.
4.2 INSTALLATION SPACE
4.3 LOCATION AND MINIMUM FREE SPACE
Consult the installation instructions for the
installation of the stove.
The Varda and Narvik are supplied with two
brackets on both sides at the bottom.
Remove the ‘M8’ screw A from the rear bracket
B. Remove the right-hand screw of the 2 sheet-
metal screws. Adjust the height of the bracket
using the other sheet-metal screw in the slotted
hole C. You can use the front brackets D to
adjust the whole stove more precisely by turning
the M8 screw E.
652
253
754/654
820/720
796/696
12
595
692
A
C
B
fig. 9 Varda/Narvik
A: Set of screws 10 mm, adjustable
B: Minimum built-in height
C: Connection cable
D
E
B
C
A
fig. 10 Varda/Narvik
fig. 11
fig. 12
