11
EN
10
EN
IVAR/OTHELLO
To gain access to the lamps open the firebox
door. Remove the two screws securing the fuel
effect.
Remove the fuel assembly by lifting the logs
slightly and sliding out
Unscrew the defective lamp anti-clockwise.
Replace with a 230 V, 40 W E14 SES lamp, do
not over tighten. Refit fuel effect and close the
firebox door (fig. 17).
ALMA
To gain acces to the lamps open the ashpan
flap control cover. Lift the flame effect window
upwards and remove. Remove the fuel
assembly by lifting slightly and sliding out.
Unscrew the defective lamp anti-clockwise.
Replace with a 230 V, 40 W E14 SES lamp, do
not over tighten.
Refit fuel assembly and slide up against the
inner glass. Replace the flame effect window
(fig. 18).
6. CLEANING AND MAINTENANCE
Always disconnect from the power supply before attempting any
maintenance.
6.1 CLEANING
Before commencing cleaning, unplug the heater and allow it to
cool.
The surface of the heater should be given an occasional wipe
over with a soft damp cloth. Do not use detergents abrasive
cleaning powder or polish on the body of the heater. The glass
screen should be cleaned carefully with a chamois leather. Do
not use proprietary glass cleaners.
6.2 LAMP REPLACEMENT
VARDA/NARVIK
To gain acces to the lamps open the Ashpan
flap. Carefully slide out the lampholder tray.
Unscrew the defective lamp anti-clockwise.
Replace with a 230 V, 40 W E14 SES lamp, do
not over tighten (fig. 16).
Refit the lampholder tray.
Warning:
fig. 16
fig. 17
fig. 18