Faber Presence, Руководство по установке и инструкция пользователя, Страница: 7 / 24

6 < < < <
UK IRL
3.3 Requirements flue system and outlets
Top outlet
The flue connector collar is for connection to
a 125 mm (5 inch) internal diameter pipe or
liner according BS EN 1856.
The minimum effective height of the flue
system must be 3 meter.
Rear outlet
In case of an installation in a masonry
chimney convert the outlet to the rear outlet.
Therefore unscrew the top outlet and fit the
rear outlet on the fire. Take care to fill up all
the holes with the screws.(see fig.1.3)
To collect the debris, there must be a
minimum gap of 23 mm behind the appliance
Use the supplied glass fibred-seal to seal the
fire box to the builders opening.(see fig.1.2)
Chimney
The top of the chimney must always be higher
then the top of the roof.
4 Preparation and Installation
instructions
4.1 Gas connection
The gas connection must comply with locally
valid standards.
We advise Pipe work from the meter to the
appliance must be of adequate size. An
isolator is factory fitted, no further isolation
device is required. Place the gas connection
in such a way that it is accessible for service
and the burner unit can be disconnected at all
times.
4.2
Preparation of the appliance
•
Remove the packaging of the
appliance.
•
Clear a safe space to store the glass.
•
Remove the glass (see chapter 5) and
take the separately wrapped parts out
of the appliance.
•
Prepare the gas connection.
•
Prepare the flue connection.
•
If necessary convert to rear outlet
(see chapter 3.3).
•
If necessary convert to framed
version.
Therefore:
A.
Remove the build in frame (see
fig.3.1)
B. Fit the frame support. (see
fig.3.2)
C. The frame now can be hung on
the support. (see fig.3.3)
4.3
Batteries.
The battery pack is fixed on a chain inside the
burner unit on the right side. (see fig.2.2)
Pull the chain to remove it.
To avoid overheating take care that the
battery pack always is positioned correctly
in the burner unit.
4.4
Placing the appliance
Take the installation requirements into
account (see chapter 3).
Masonry chimney
Cut out the opening so that the appliance can
be fitted easily.
prepare the 2 non combustible supports on
the left and the right side in the builders
opening (see fig. 1.1)
For a Top outlet connection
Pull a 5 inch liner into the chimney.
Fit the fire in the builders opening and
connect the liner on the top outlet.
For a Rear outlet installation
Fit the fire in the builders opening, use the
supplied glass fibred-seal to seal the fire box
to the builders opening.(see fig.1.3)
Do a gas leakage test on all joints and check
burner and inlet pressure.
See chapter 7 before closing the chimney
Reconstruct the wall of the chimney.
5 Removing the glass
•
Place the suction discs onto the glass
•
Remove the cover strips on the left
and right side by pushing the top (see
fig.1.4)
•
Remove the cover strips on the left
and right hand side (see fig.1.5)
•
Remove the sealing cord from the
groove (see fig.1.6)
• Lift the glass up and move slowly
forward, now you can take the glass
out.
To replace the glass repeat the process in
reverse order.
Remove all Fingerprints from the glass, these
will be burned into it once the hearth is used.