Faber Presence, Руководство по установке и инструкция пользователя, Страница: 18 / 24

17 < < < <
UK IRL
15 Introduction
Because this appliance is a source of heat, air
circulation will arise. That is why it is
important that you do not use the fire shortly
after a renovation. By natural air circulation
moisture and volatile components from paint,
building materials, floor coverings etc. that
haven’t set yet, are sucked up. These
components can be deposited on cold surfaces
as soot. The first time you should use the fire
depends on various circumstances. Consult
your gas fitter on this matter.
16 Cleaning and Maintenance
•
The appliance will have to be cleaned
and serviced and the proper
functioning checked by a gas fitter.
•
The outside frame of the fire can be
cleaned with a clean damp cloth.
16.1
Cleaning the glass
•
Dismount the glass according to the
description in the installation
instructions.
•
Remove the deposit with a clean dry
cloth. If necessary, a special ceramic
cleaning agent can be used.
Note: prevent the making of finger marks on
the glass. These cannot be removed once the
fire has burnt them into the glass!
17 Safety Instructions for the User
•
The appliance has been designed for
atmospheric and heating purposes. This
means that all surfaces of the fire,
including the glass, can become very hot
(hotter than 100 °C). An exception to this
is the on-off switch of the fire
•
If the fire has been switched off, wait for
at least three minutes before re-igniting
it again.
•
If the fire switches off with no known
cause, wait for at least 15 minutes
before re-igniting the fire again. If this
happens repeatedly, get in touch with
your gas fitter.
•
The fire should not be used if:
-
The glass is damaged or has been
removed.
-
The combustion chamber is open.
•
Don’t place any inflammable materials
in the combustion chamber.
•
Never change the position of the log set
and never add more decorative
materials or carrara pebbles than have
been supplied with the appliance. If the
fire is switched on, the pilot light should
always be visible!
•
Don’t place any curtains, clothes,
laundry, furniture or other inflammable
materials in the neighbourhood of the
appliance. The minimum safe distance is
100 cm.
•
Don’t allow children to use the remote
control unit without adult supervision.
•
Fit a suitable fireguard if there are
children, old people or persons with
limited mobility present in the same
room.
18 First time the fire is operated
Before ignition, remove all stickers,
protective wrappings and, if present, rubber
protective padding from the glass.
Make sure the room is properly ventilated the
first time the fire is switched on. Burn the
appliance at the highest position for some
hours so that the lacquer coating will have an
opportunity to set and possible vapours
released can be safely removed by
ventilation. Keep children and pets outside
the room during this process!
18.1
Remote control unit – general remarks
The appliance has been supplied with a
remote control set; The receiver and the gas
control are located underneath the burner.
Access only allowed by a competent person
•
The remote control has been provided
with 3 keys (fig.1.4). All functions of
the fire can be operated with these
keys.
•
If the transmission is successful, the
receiver will emit a sound signal.
•
With the On/Off switch (fig. 1.1) the
fire can always be switched off.
•
Switch in O position –, if the fire is
not in use for a longer period.
•
When using the thermostat/timer
function, the wall bracket supplied
(fig. 2.3/2.4/2.5) should always be
placed within 4 metres of the
appliance .
18.2 batteries
The battery pack for the receiver is fixed on a
chain and store on the right side underneath
the burner unit. (see fig. 1.3)