Faber Presence, Руководство по установке и инструкция пользователя, Страница: 6 / 24

5 < < < <
UK IRL
1 Introduction
The fire can only be installed by a competent
person in accordance with the Gas Safety
Installation and Use regulations. We urgently
advise you to read this installation manual
properly.
This appliance complies with the guidelines
for European gas appliances (Gas Appliances
Directive) and bears the CE mark.
2 Safety instructions.
• The appliance should be placed,
connected and annually checked in
accordance with these installation
instructions and valid national and
local Gas Safety (Installation and Use)
Regulations .
•
Check whether the data on the
registration plate are in agreement
with the local type of domestic gas
and pressure.
•
It is not permitted to change the
adjustments or the construction of
the appliance!
•
Do not place any additional imitation
logs or glowing coals on the burner or
in the combustion chamber.
•
The appliance has been designed for
ambience and heating purposes. This
means that all surfaces of the
appliance , including the glass, can
become very hot (hotter than 100
°C). An exception to this are the
bottom of the appliance and the
controls.
•
Do not place any combustible
materials within 0.5 m. of the
radiation of the appliance and
ventilation grills.
•
Due to natural air circulation of the
appliance, moisture and volatile
components from paint, building
materials, floor coverings etc. that
haven’t yet set, can be drawn through
the convection system and can be
deposited on cold surfaces as soot.
That is why you should not use the
appliance shortly after a renovation.
•
The first time the appliance is
switched on, Let the fire run on
maximum setting for several hours so
that the lacquer coating will have an
opportunity to set and possible
vapours released can be safely
removed by ventilation. We advise
you to be outside the room as much
as possible during this process!
•
Please note that:
1. all transport packaging should be
removed.
2. children or pets should not be
present in the room.
•
No extra ventilation is required, due
to the fact that the input of the
appliance is not exceeding 7,0 kW.
3 Installation requirements
3.1 The fire
The fire is tested for installation without a
hearth.
Make 2 non combustible supports on the left
and the right side of the burner unit. (see fig.
1.1)
3.2
Chimney breast
The appliance must be built into a non
combustible existing or a new to be
constructed false chimney breast.
For the dimensions of the builders opening
see fig.1.7.
framed frameless
A = 670mm 670mm
B = Min. 100mm Min. 100mm
C = 337mm 337mm+wall thickness
D = max. 60mm wall thickness
E = 460mm 430mm
Combustible shelf
F = min.
350mm
G = max.150mm
If the shelf depth is greater than 150mm, add
50 mm to shelf clearance height for every 25
mm increase in shelf depth
For the dimensions of the fire see chapter 11
till 14.
The false chimney breast must be ventilated
on top and bottom with a minimum opening
of 200cm2.
The false chimney breast and its construction
may not rest on the appliance.
Therefore always use a lintel for a brick build
chimney.
For the minimum dimensions see fig 1.8.
For the finish, use special stucco (min. 100°C
resistant) or glass fibre wallpaper to prevent
discoloration or cracks etc. Recommended
drying time: for plaster is a minimum of 24
hours per mm of coat applied.