Faber MatriX 800/500 RD H, Руководство по установке

Страница: 14 / 36

Installation manual MatriX 800-1050x500 RD,ST H
13 < < < <

Pay extra attention to the fitting of the logs,
the logs must be able to slide slightly over the
burner tubes.

If necessary, increase block 1 with glass
granulate so that there is no free space
between blocks 1 and 2.
Fine tuning of the LED light;
By placing grey chips pieces (possibly breaking) in
front of the light guides, you can largely hide them
from view.
Check points after decorating:
1. Ignition pin free from decoration
2. Ionisation pen free from decoration
3. Light on the tribes
4. Glow bed
5. Are all light guides free from decoration
material.
6. Sufficient decorative material used.
First start, pay attention! Do this without the
glass plates in the fireplace.

Start the fire as described in the user manual.

Assess the flame distribution and the glow
effect on the logs. Move or remove chips if
necessary to create a nice glow bed.

Switch off the fire

Place the glass (see Chapter 5)
7 Checking the installation
Checking for gas leaks
Check with a gas leak finder all connections and
pipes for gas leakage.
Check inlet pressure
Check if the inlet pressure correspond to the data
on the rating plate.
Measuring the inlet pressure:

Close the shutoff valve. Turn the
measuring nipple “E” (fig. 1.2) a few turns
to open and connect a measuring hose to
the gas valve.

Take this measurement when the
fireplace runs at high and low settings.

Do not use the device if the inlet pressure
deviates (+20% or -20%).

Please note!
Close the pressure measuring nipple and check
for gas leakage.
Check ignition and burner
Ignite the fireplace by using the remote control as
described in the user manual and test all burner
possibilities.
Check:
All section settings of the burners.
Now repeat the above check using the ITC-V2 APP.
(App set at Dealer level).
Navigate to Settings / Diagnosis and,
• the Current readings
• the Diagnosis messages
7.1 Checking the flame image
Let the fireplace burn for at least 20 minutes at
highest setting and check the flame for:

flame distribution;

colour of the flames.
If one or both points are not acceptable then
check:

The position of the logs and/or the
amount of glass granulates;

The pipe connections for leaks.
(in case of blue flames);

That the correct flue restrictor is fitted
(see fig. ??);

The outlet:
o
Wall terminal has the correct
position and side up;
o
Roof terminal has the correct
position.

If the maximum lengths of the flue gas
outlet is not exceeded.

If possible, carry out a flue gas analysis
(see section 7.2).
7.2 Flue gas analysis
It is possible to check the combustion gases and
supply air with a CO/CO
2
flue gas analyser.
There are two measuring pipes between the built-
in frame and the front glass (fig.21a and b).
X = measuring pipe air supply
Y = measuring pipe flue gas
The ratio CO2 and CO must not be greater than
1:100.
Example:
CO2 is 4% and CO is 400ppm, measured at the
highest point. If the ratio is greater than 1:100 or
flue gases are measured in the air supply, check
the points in section 7.1.